After a Netapp failed disk swap, if an autosupport message is sent saying that the disk firmware is downrev, please run the following command.

filer1> disk_fw_update

Make sure that the disk firmware is upto-date by checking /etc/messages file for the below message
— Firmware downloaded on disk
— Firmware is up-to-date on all disk drives

0 Shares:
Leave a Reply

Your email address will not be published. Required fields are marked *

You May Also Like
Read More

AIX syslog

By default, syslog is not enabled on an AIX system. The default install on an AIX install will…
Read More

Some Netapp terms..

Snapshot – is a technology that helps to create point-in-time copies of file systems, which you can use…